Toshiba B-SX5 Series - Automatic Self-Test; Memory Check; Sensor Check

- 44 -
• Web printer function setting
• Reset process when the nInit signal is ON
• Ribbon near end detection setting
• Expansion I/O operation mode setting
• Centronics operation mode setting
• Plug-and-play operation setting
• Label end/ribbon end process setting
• Pre-peel-off process setting
• Back feed speed setting
• MaxiCode specification setting
• Print head type setting
• IP address setting
• BASIC setting
• Socket communication port number setting
• BASIC interpreter setting
• DHCP setting
• Wireless LAN setting
• RFID module type selection
• RFID tag type selection
• RFID error tag detection
• Max. number of RFID issue retries
• Max. number of RFID read retries
• RFID read retry time-out
• Max. number of RFID write retries
• RFID write retry time-out
• RFID adjustment for retry
• RFID wireless power level setting
• RFID AGC threshold setting
• RFID channel setting
• Number of successful RFID write
• Number of failure in RFID write
• System mode password setting
• XML function setting (V4.4A only)
(2) Automatic self-test
c Memory check
• Program area (Model, creation date, version, part number, checksum)
• Boot area (Model, creation date, version, checksum)
• Font area checksum
• Bit map Kanji ROM checksum (Gothic, Mincho, Chinese Kanji)
• EEPROM check
• RAM check
• Card check
d Sensor check
• Strip sensor
• Thermal head open sensor
• Thermal head-up sensor
• Rewinder overflow sensor
• Cutter home position sensor
• Ribbon rewind motor sensor
• Ribbon back tension motor sensor
• Thermal head temperature sensor
• Open-air temperature sensor
• Heat sink sensor