Toshiba B-SX5 Series - Automatic Self-Test Printout

- 47 -
NOTE: Print conditions: 288 mm of label length, thermal transfer/direct thermal print
mode
(*1)
, no sensor used, 6 ips/5 ips
(*2)
, one sheet to print, batch
issue, no driving of paper rewind motor
(*1) Depends on the print type setting.
(*2) B-SX4: 6 ips, B-SX5: 5 ips
(2) Automatic self-test printout
NOTES: 1. Print conditions: 87 mm of label length, thermal transfer/direct thermal print
mode
(*1)
, no sensor used, 6 ips/5 ips
(*2)
, one sheet to print,
batch issue, no driving of paper rewind motor
(*1) Depends on the ribbon designation setting.
(*2) B-SX4: 6 ips, B-SX5: 5 ips
2. “°” used for “°C” may not be printed correctly, depending on the types of the
character code.
PROGRAM B-SX4T 7FM00226000
MAIN 15OCT2002 V1.0A:1A00
BOOT 20SEP2002 V1.0 :8500
FONT 5600
KANJI NONE :0000
NONE :0000
EEPROM OK
SDRAM 8MB
CARD SLOT 1 ATA
SLOT 2 LAN
SENSOR1 00000000,00000111
SENSOR2 [H]23°C [A]22°C [S]25°C
[R]4.2V [T]2.5V [E]0.6V
[RANK]7
EXP.I/O NG
EX.232C NG
RFID OK V2.17M
When the MAIN PC Board type is the
PWA-SX MAIN2 (Part No.: 7FM00503x00),
the heat sink sensor status is not printed.
When the firmware version of the MAIN PC
Board is V4.1:xx00 or later, drawing
number for the software is not printed.