- 51 -
Item Contents Remarks
MESSAGE Language selection for LCD
messages
ENGLISH: English
GERMAN: German
FRENCH: French
DUTCH: Dutch
SPANISH: Spanish
JAPANESE: Japanese
ITALIAN: Italian
FORWARD WAIT Forward feed standby after an
issue
ON: Performed
(A fine adjustment value for
the stop position is also
printed.)
OFF: Not performed
FW/BK ACT. Forward feed standby action MODE 1: Stops after 13.7-mm
forward feed.
MODE 2: Stops after 6-mm back
feed and 3-mm forward
feed. (Only when the cut
mode, thermal transfer,
and feed gap sensor are
selected.) In other
cases, the printer stops
after 13.7-mm forward
feed.
HU CUT/RWD. Head-up operation in cut issue
mode, or use of the rewinder
ON: Head-up operation is
performed, or the rewinder is
used.
OFF: Head-up operation is not
performed, or the rewinder is
not used.
Ribbon saving system setting ON(TAG): Used when the head
lever position is “TAG”.
ON(LBL): Used when the head
lever position is
“LABEL”.
OFF: Not used
RIBBON SAVE
Installed solenoid type setting TYPE 1 (TDS-12C)
TYPE 2 (TDS-16A: Stronger pull
force type)
CODE Control code type AUTO: Automatic selection
ESC LF NUL: ESC LF NUL
method
{ | }: { | } method
××{{UU Any set code
(Described in hex.
code)
PEEL OFF STS Peel-off wait status selection ON: Selected
OFF: Not selected
FEED KEY [FEED] key function setting FEED: One label is fed.
PRINT: Data in the image buffer is
printed on one label.
KANJI Kanji code type TYPE1: For Windows codes
TYPE2: For original codes
EURO CODE Euro code setting 20H to FFH
To Next Page
Loading...
