- 52 -
Item Contents Remarks
AUTO HD CHK Automatic broken dots check
setting
ON: Automatic broken dots check
is performed.
OFF: Automatic broken dots check
is not performed.
ACK/BUSY Centronics ACK/BUSY timing
setting
TYPE 1: The ACK signal is sent to
match the rising edge of
ACK signal and the falling
edge of the BUSY signal.
TYPE 2: The ACK signal is sent to
match the falling edge of
ACK signal and the falling
edge of the BUSY signal.
WEB PRINTER Web printer function setting ON: Enabled
OFF: Disabled
INPUT PRIME Reset process when the nInit
signal is ON
ON: Reset is performed.
OFF: Reset is not performed.
RIBBON NEAR END Ribbon near end detection setting 30 m: Ribbon near end state is
detected when the remaining
ribbon length is
approximately 30 m.
70 m: Ribbon near end state is
detected when the remaining
ribbon length is
approximately 70 m.
OFF: Ribbon near end state is not
detected.
EX.I/O MODE Expansion I/O operation mode TYPE1: Standard mode
TYPE2: In-line mode
CENTRO MODE Centronics operation mode SPP: Compatibility mode
ECP: ECP mode
PLUG & PLAY Plug-and-play operation setting ON: Plug-and-play operation is
enabled.
OFF: Plug-and-play operation is
disabled.
LBL/RBN END Label end/ribbon end process
setting
TYPE1: When a label end or
ribbon end state is
detected, the printer stops
even if it is printing.
TYPE2: When a label end or
ribbon end state is
detected, the printer prints
the current label as far as
possible, then stops.
PRE PEEL OFF Pre-peel-off process setting ON: Pre-peel-off operation is
performed.
OFF: Pre-peel-off operation is not
performed.
BACK SPEED Back feed speed setting STD: 3 ips
LOW: 2 ips
MAXI CODE SPEC. MaxiCode specification setting TYPE1: Compatible with the
current version
TYPE2: Special specification
THERMAL HEAD Print head type setting B-SX4 B-SX5
V1: TPH104R2, V1: TPH128R4,
V2: TPH104R7, V2: TPH128R5,
or equivalent or equivalent
To Next Page
Loading...
