- 54 -
Item Contents Remarks
RFID MODULE RFID module type selection NONE: No RFID kit is installed.
U1: B-9704-RFID-U1-EU/US
H1: B-9704-RFID-H1-QM
H2: B-SX704-RFID-H2
U2: B-SX704-RFID-U2
RFID TAG TYPE RFID tag type selection I-Code: 11
Tag-it: 12
C220: 13
ISO15693: 14
C210: 15
C240: 16
C320: 17
EPC Class0: 21
EPC Class1: 22
ISO18000-6B: 23
EPC C1 Gen2: 24
RFID ERR CHECK RFID error tag detection ON: Detection is enabled.
OFF: Detection is disabled.
RFID RETRY Max. number of RFID issue retries 0 to 255
RFID RD CYCLE Max. number of RFID read retries
RFID read retry time-out
0 to 255
0 to 9.9 sec.
RFID WT CYCLE Max. number of RFID write retries
RFID write retry time-out
0 to 255
0 to 9.9 sec.
RFID ADJ RETRY RFID adjustment for retry -99 mm to +99 mm
RFID POWER LEVEL RFID wireless power level setting 0 to 255 (for the B-9704-RFID-U1-
US/EU)
18 to 26 (for the B-SX704-RFID-
U2)
RFID THRESHOLD RFID AGC threshold setting 0 to 15
RFID RF CHANNEL RFID channel setting 2CH to 8CH
AUTO
XML SPEC
(Supported only
by V4.4A)
XML function setting STD: Standard specification
ORACLE: Specification for Oracle
NOTE: For the B-SX4, the head density is 8 dots/mm. If the value is set to “x.2 mm” or “x.3
mm”, the operation to be performed is the same for both. Therefore, “x.3 mm” is
printed on the maintenance counter printout, even if “x.2 mm” is set. Similarly, if “x.7
mm” is set, “x.8 mm” is printed on the maintenance counter printout.
To Next Page
Loading...
