Toshiba B-SX5 Series - Expansion I;O Operation Mode Setting (EX. I;O); Reset Process When the Ninit Signal Is on (INPUT PRIME); Ribbon Near End Detection Setting (RBN NEAR END); Web Printer Function Setting (WEB PRINTER)

- 69 -
(21) Web printer function setting (WEB PRINTER)
• OFF: Web printer function is disabled.
• ON: Web printer function is enabled.
(22) Reset process when the nInit signal is ON (INPUT PRIME)
• OFF: The reset process is not performed.
• ON: The reset process is performed.
(23) Ribbon near end detection setting (RBN NEAR END)
• 70 m: A ribbon near end state is detected when the remaining ribbon
length is 70 m.
• 30 m: A ribbon near end state is detected when the remaining ribbon
length is 30 m.
• OFF: A ribbon near end state is not detected.
NOTE: There are some variations in detecting the ribbon near end
state. It is preferable to use this setting for reference
purposes.
(24) Expansion I/O operation mode setting (EX. I/O)
• TYPE1: Standard mode
• TYPE2: In-line mode
(25) Centronics operation mode setting (CENTRO.)
• SPP: Compatibility mode
• ECP: ECP mode
FEED
RESTART
FEED
RESTART
FEED
RESTART
FEED
RESTART
FEED
RESTART