Toshiba B-SX5 Series - Supplementary Explanation

- 6 -
T R A N S M I S S I V E
B - S X 4 T V 1 . 0 A
T R A N S M I S S I V E
B - S X 4 T V 1 . 0 A
P A U S E
B - S X 4 T V 1 . 0 A
O N L I N E
B - S X 4 T V 1 . 0 A
O N L I N E
B - S X 4 T V 1 . 0 A
<Supplementary Explanation>
(1) When the [PAUSE] key is released within 3 seconds while the printer is paused, the
[PAUSE] key is invalid.
(2) To program the threshold, 1.5 sheets or more of the label should be fed. (If the label is not
fed by the above amount, the threshold may not be properly programmed. In this case,
reprogramming is required.)
(3) Even if the [PAUSE] key is held down for 3 seconds or more when the head is lifted, the
[PAUSE] key is invalid.
(4) While the printer is feeding a label to program the threshold, an error detection including the
paper end or cutter error is not performed.
(5) When the proper print position is not obtained after threshold programming, the sensor may
be improperly adjusted. In this case, readjust the sensor in system mode, and program the
threshold.
When the backing paper of the label is too thick, the transmissive sensor should be
readjusted.
In addition, make sure that “3: Transmissive sensor (when using the preprinted label)” or “4:
Reflective sensor (when using a manual threshold value)” is selected for sensor type of the
Feed Command and the Issue Command.
(13) When the [PAUSE] key is released
after 1.5 sheets or more of the label
are fed, the printer stops feeding the
label.
(Threshold setting for the selected
sensor is completed.)
(16) The label is printed according to the
command issued from the PC.
(15) Idling
(12) The printer feeds the label until the
[PAUSE] key is released.
(14) Press the [RESTART] key.
[RESTART]
(10) The transmissive sensor designation is
displayed.
Command
(11) Continue holding down the [PAUSE]
key.
[PAUSE]