Toshiba B-SX5T Series - Page 109

APPENDIX 2 INTERFACE ENGLISH VERSION EO1-33059
APPENDIX 2 INTERFACE
EA2- 4
 LAN (Option: B-9700-LAN-QM-R)
Physical Layer: IEEE802.3 10BASE-T/100BASE-TX
Number of ports: 1
Connector: RJ-45
LED status: Link LED, Activity LED
LAN cable: 10BASE-T: UTP category 3 or category 5
100BASE-TX: UTP category 5
Cable length: Segment length Max. 100 m
 Wireless LAN (Option: B-9700-WLAN-QM-R)
Standard: Conforming to IEEE802.11a, IEEE802.11b, and IEEE802.11g
Protocol: IP (RFC791), ICMP (RFC792), UDP (RFC768), TCP (RFC793,896), ARP
(RFC826), HTTPD (RFC1866), TELNET, FTPD (RFC959), DHCP (RFC2131),
SNMP
Security protocol: WEP (64 bits/128 bits/152 bits) or AES, AES-OCB (128 bits)
TKIP (only when using WPA, WPA-PSK)
TWSL (unique encryption)
Antenna: Chip type, diversity antenna
Parameter setting: via HTTP
Default IP address: 192.168.10.21
Default subnet mask: 255.255.255.0
N
OTES:
1. For IP address setting, refer to the B-SX4T/SX5T Series Key Operation Specification stored in the CD-
ROM.
2. When a generally-used twisted pair Ethernet (TPE) or UTP cable is used, a communication error ma
y
occur depending on your operating environment. In such case, you may be requested to use a shielde
d
twisted pair cable.
Link LED (Green)
A
ctivity LED (Orange)
LED LED Status LAN status
ON 10Mbps link or 100Mbps link is detected. Link
OFF No link is detected.
* Communication cannot be made while the
Link LED is off.
ON Communicating Activity
OFF Idle
N
OTE:
M
AC address of the Wireless LAN module will be necessary when setting the MAC address filtering function of an
access point. Please ask a service person of your nearest TOSHIBA TEC service representative.