2. SUPPLY SPECIFICATIONS EO10-33013B
(Revision Date: May 22, 2009)
2.7 SPECIFICATION OF RFID TAG (for B-SX704-RFID-U2-CN -R)
2-27
(1) Omron Wave tag
It is recommended to locate the vertical center of an RFID tag at 38 mm ± 3 mm from a leading edge of
a label and align the horizontal center with the horizontal center of the label.
[Printer settings for use of this tag]
In the printer system mode, set the RFID-related parameters as follows:
Q value: 2, WT AGC (AGC threshold for data write): 10, WT MIN AGC (AGC threshold lower limit for
retry): 10
As the AGC value of this tag is high, the antenna may be able to communicate with non-target tags.
To prevent interferences from non-target tags, a target tag is identified by measuring the AGC of the
tags within the read range. A tag of which AGC is equal to or higher than the specified threshold (10)
is considered to be positioned just above the antenna (=target tag), and a data write is performed on it.
When the AGC is less than the threshold, a data write is not performed on such tags.
38 mm ±3 mm
Media feed direction
To Next Page
Loading...
