Toshiba B-SX6T Series - Strip Motor Torque Selection; Stabilizer Function Selection

2. SYSTEM MODE EO13-33002
2.2 Parameter Setting
2-34
2.2.29 Strip Motor Torque Selection
This parameter is to choose a strip motor torque.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
NOTE: This parameter is fixed to R0.
Press the [PAUSE] key to skip.
2.2.30 Stabilizer Function Selection
This parameter is to choose whether to use the stabilizer function.
The stabilizer function reduces the sound of printing.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting the stabilizer function, press the [PAUSE] key.
NOTE: The stabilizer function is available only to the thermal direct print mode.
<2>PARAMETER SET
PEEL OFF TRQ R0
<2>PARAMETER SET
STABILIZER ON
STABILIZER ON
[RESTART]
[FEED]
ON: Sound of printing is reduced.
OFF: Normal printing
STABILIZER OFF