Toshiba B-SX6T Series - Page 13

INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO15-33002
3. Ribbon Saving Module: B-SX908-R-QM-R
3- 3
7. Fit the locking supports into the RSV PC board, then connect the solenoid (L) harness to CN1 on the
RSV PC board.
8. Attach the blind plate (R) to the solenoid (R) with the two SM-3x5 screws.
9. Draw the two harnesses (2 pins, 3 pins) from the head block, then connect the harness (2 pins) and the
harness (3 pins) into CN2 and CN3 on the RSV PC board.
RSV PC Board
CN1
Harness
Solenoid (L)
SM-3x5 Scre
w
Solenoid (R)
Blind Plate (R)
Harness (3 pins)
Harness (2 pins)
CN3
CN2
RSV PC Board