INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
EO15-33002
3. Ribbon Saving Module: B-SX908-R-QM-R
3- 4
10. Connect the solenoid (R) harness to the head block harness.
11. While inserting the head up link into the spring pin of the solenoid, attach the solenoids (L) and (R) to
the head block.
Note: It is easier to attach the solenoid in the following procedure. First remove the plunger from the
solenoid. Next, insert the head up link into the plunger then the plunger into the solenoid.
Solenoid (R)
Harness
Spring Pin
Head Up Lin
To Next Page
Loading...
