2. PRINTER SETUP ENGLISH VERSION EO1-33056
2.4 Loading the Media
E2-13
2.4 Loading the Media
(Cont.)
15. Change the print head pressure according to the thickness of the
media to be used, by using the Head Lever.
Position Media type or thickness
Label or Thin media
1
If a clear print cannot be obtained,
change the position to
d.
Tag paper or Thick paper
2
If a clear print cannot be obtained,
change the position to
c.
16. If the loaded media is direct thermal media (with a chemically
treated surface), the media loading procedure is now completed.
If the media is normal media, it is also necessary to load a ribbon.
Refer to Section 2.5 Loading the Ribbon.
Head Leve
To Next Page
Loading...
