Toshiba BA400 Series - 9.8 Issue Control

142
9.8 ISSUE CONTROL
Menu item
<5> ISSUE CONTROL
Sensor
Mode
Print speed
Ribbon
Direction
Auto status
Sensor
COMMAND
NO
REFLECTIVE
TR.Threshold1
TR.Threshold2
TR.Threshold3
TR.Threshold4
TR.Threshold5
RE.Threshold1
RE.Threshold2
RE.Threshold3
RE.Threshold4
RE.Threshold5
* This setting is disabled when the auto calibration setting is enabled.
Mode
COMMAND
BATCH
CUT( 1)
PEEL OFF
PEEL OFF (Appl)
* If cut is selected, the cut multiple sheet setting is fixed at 1.
Print speed
COMMAND
2 ips
4 ips
6 ips
8 ips
* When 2 ips is set, only thermal transfer works at 3 ips.
Ribbon
COMMAND
NO (Direct)
YES
Direction
COMMAND
BOTTOM
TOP
BOTM/Mir
TOP/Mir
Auto status
COMMAND
OFF