Toshiba BA400 Series - 8.4.1 Maintenance Counter

42
8.4.1 MAINTENANCE COUNTER
The following table shows the menu structure from the top menu of the system mode to MAINTENANCE
COUNTER.
Menu item
<1>DIAGNOSTIC
MAINTENANCE COUNTER
THERMAL TRANSFER
PAPER CUTTING
NO
YES
DIRECT THERMAL
PAPER CUTTING
NO
YES
DISPLAY
COUNTER
ADJUSTMENT(PC)
STORAGE AREA
USB SERIAL NUMBER
WLAN AUTHENTICATION
RFID TAG COUNT
Notes:
1. The MAINTENANCE COUNTER enables selecting whether to print or display the self-diag. test result
(maintenance counter data and parameter settings). When THERMAL TRANSFER or DIRECT THERMAL
is selected, the test result is printed. When DISPLAY is selected, the test result is displayed on the LCD.
2. When an error occurs while printing, the error message is displayed, the ERROR LED turns on, and the
ONLINE LED turns off. Though the error can be cleared by pressing the [PAUSE], key, the printer does not
reprint the label automatically.
3. Menu operation example
Display
Procedure
1
SYSTEM MODE C1.6
▲
<1>DIAGNOSTIC
<3>TEST PRINT
▼
<0>RESET
<2>SET PARAMETERS
1. Turn off the printer.
2. Turn on the printer while holding down [FEED] and
[PAUSE] keys at the same time.
3. The top menu of the SYSTEM MODE is displayed.
2
SYSTEM MODE C1.6
▲
<1>DIAGNOSTIC
<3>TEST PRINT
▼
<0>RESET
<2>SET PARAMETERS
1. Select <1>DIAGNOSTIC.
2. Press the [PAUSE] key.
3. Submenus of <1>DIAGNOSTIC are displayed.
3
<1>DIAGNOSTIC C1.6
▲
AUTO DIAGNOSTIC
▼
MAINTENANCE COUNTER
HEAD CHECK
1. Select MAINTENANCE COUNTER.
2. Press the [PAUSE] key.
3. PRINT TYPE menu is displayed.
4
When THERMAL TRANSFER or DIRECT THERMAL is selected:
Note: When DISPLAY is selected, go to step 5.