2. PRINTER SETUP ENGLISH VERSION
2.4 Loading the Ribbon
E2-
12
2.4 Loading the Ribbon
(Cont.)
3. Open the Top Cover.
4. Open the Ribbon Cover.
5. Fit the ribbon take-up core into the Ribbon Holder (Take-up side),
aligning the notch of the ribbon core with the protrusion of the Ribbon
Stopper.
6. Turn the ribbon take-up core in the direction indicated by the arrow to
remove any slack.
1. Be sure to remove any
slack in the ribbon when
printing. Printing with a
wrinkled ribbon will lower
the print quality.
2. When a ribbon end is
detected, “RIBBON
ERROR” message will
appear on the display and
the ERROR LED will
illuminate.
3. When disposing of the
ribbons, please follow the
local rules.
(Take-up side)
Stopper
To Next Page
Loading...
