Toshiba BA420T Series - Page 22

2. PRINTER SETUP ENGLISH VERSION
2.4 Loading the Ribbon
E2-
12
2.4 Loading the Ribbon
(Cont.)
3. Open the Top Cover.
4. Open the Ribbon Cover.
5. Fit the ribbon take-up core into the Ribbon Holder (Take-up side),
aligning the notch of the ribbon core with the protrusion of the Ribbon
Stopper.
6. Turn the ribbon take-up core in the direction indicated by the arrow to
remove any slack.
45°
NOTES:
1. Be sure to remove any
slack in the ribbon when
printing. Printing with a
wrinkled ribbon will lower
the print quality.
2. When a ribbon end is
detected, “RIBBON
ERROR” message will
appear on the display and
the ERROR LED will
illuminate.
3. When disposing of the
ribbons, please follow the
local rules.
Ribbon Cover
Top Cover
Ribbon Holder
(Take-up side)
Top Cover
Stopper