Toshiba BC Series - Baudrate

34 / 73
Copyright © 2019 Toshiba Teli Corporation, All Rights Reserved. http://www.toshiba-teli.co.jp/en/
D4296087A
Baudrate
If GenCP used, the baudrate is possible to change.
*In Legacy protocol used, the baudrate is fixed 9600 bps.
● Registers
GenCP protcol
Register
address
Read
Write
Memory
save
Default
Register name
Description
0x0001 0000
R.O.
-
0x91
Supported Baudrates
9600/115200/921600 bps
0x0001 0004
R/W
-
0x0
Current Baudrate
Set baudrate.
0x0:auto recognition, 0x1:9600bps, 0x10:115200bps, 0x80:921600bps
● Control procedure
■ In the case of baudrate automatic recognition (CurrentBaudrate = 0x00)
The camera automatically recognizes the baudrate of the received command and responds with the same
baudrate. The PC application can be accessed immediately at the desired baudrate without changing the
camera settings. The baudrate supported for automatic recognition are 9,600 bps, 115,200 bps, and
921,600 bps.
■ In case of baudrate specification operation (CurrentBaudrate = 0x01 / 0x10 / 0x80)
The camera only receives commands at the specified baudrate.
Please refer to GenCP specification for switching sequence.
Legacy mode is disabled during the baudrate specification operation.