Toshiba BC Series - Usersetcontrol

66 / 73
Copyright © 2019 Toshiba Teli Corporation, All Rights Reserved. http://www.toshiba-teli.co.jp/en/
D4296087A
UserSetControl
You are able to save a user setting to the non-volatile or volatile memory of the camera.
There are 15 user memory channels for user setting.
By using user memory, you are able to restore frequent used settings at the time of next start-up.
The following table is the list of registers applied to “UserSetLoad”/“UserSetSave”.
List of registers to be applied to UserSet
Category
Register name
Category
Register name
TransportlayerControl
CameraLink Tap
TriggerControl
TriggerMode
CameraLink CLK
TriggerSequence
ImageFormatControl
OffsetX
TriggerSource
Width
TriggerDelay
OffsetY
ExposureControl
ExposureTimeControl
Height
ExposureTime
BinningHorizontal
ShortExposureMode
BinningVertical
DigitalIOControl
LineInverterAll
DecimationHorizontal
AnalogControl
Gain
DecimationVertical
BlackLevel
ReverseX
Gamma
ReverseY
LUTControl
LUTEnable
PixelSize
UserSetControl
UserSetDefault
TestPattern
SequentialShutterControl
SequentialShutterEnable(*)
AcquisitionControl
AcquisitionFrameRateControl
SequentialShutterTerminateAt(*)
AcquisitionFrameRate
SequentialShutterEntry(*)
AcquisitionFrameIntervalControl
DPCControl
DPCEnable(*)
AcquisitionFrameInterval
DPCNumber(*)
HighFramerateMode
DPCEntryX(*)
DPCEntryY(*)
(*) DPC and SequentialShutter entries are stored to a single channel. Entries are shared with all channels.