2.Printer Setup
38 Loading the media
Media loading procedure
1
While pulling each of the right and left lock release portions [1] in the arrow direction, fully open
the top cover [2].
2
While holding the holder lock lever [1], extend the media holder [2] to the right and left.
3
Change the position of the core holder to match the inner diameter of the media core for the roll
media being used.
P.41 “Moving the core holder”
4
Change the position of the media damper (bottom) [1].
When an outer roll media is used: Push up the media damper (bottom) [1] until a pop sound is heard to make it
locked.
When an inner roll media is used: Pull up the media damper (bottom) [1] to release the lock.
[
2
]
[
1
]
[
1
]
[
1
]
[
2
]
To Next Page
Loading...
