Toshiba BV410T- TS02-QM-S - Procedure for Loading Media When the Cutter Module Is Attached

2.Printer Setup
Loading the media 43
Printer Setup
 Procedure for loading media when the cutter module is attached
Do not touch the cutter blade directly.
This could cause injury.
1
Load the media by following steps 1 to 7 of the normal media loading procedure.
2
Insert the end [1] of the media into the media slot [3] of the cutter module [2].
3
Pass the media under the right and left media guides [1].
Make sure that the media guides [1] do not tighten the media too much. Tightening the media too much could
bend the media, causing paper jams and media feed failures.
4
Confirm that the media pass under the media guides [1].
5
In the case of an outer roll media, push the right and left edges of the media to pass it through the
outer roll paper hooks [1].
[
1
]
[
3
]
[
2
]
[
1
]
[
1
]
[
1
]
[
1
]
[
1
]