5.Appendix
86 Specifications
RFID tag
Fundamentally, the specification of RFID tag paper conform to the specifications of print media. Items that differ are
listed in the table below. For details about ordering RFID tag paper, contact your service representative.
Unit: mm (inch)
Notes on using RFID tag paper
1. Accuracy of encoding
It is not possible to guarantee 100% encoding under all usage environments and conditions, including external
factors (noise), apart from the performance of the tag used (IC, inlay shape/size), temperature, and humidity.
Thus, be sure to conduct advance confirmation in the environment actually used. If encoding fails, horizontal
lines are printed.
2. Storing RFID tag paper
Do not store RFID tag paper near the printer because doing so could affect the reading/writing performance.
3. RFID tag paper rolls
If making RFID tag paper into a roll, pay attention to the rolling pressure. In general, RFID tag paper tends to
become curly when rolled depending on the label glue, tag, and base. Besides, for inner rolls, paper jams could
result. It is recommended to use outer rolls of RFID tag paper if there is no particular reason.
4. Sensor
If you issue paper by enabling the gap or reflective sensor, the transmittance/reflectance may vary depending on
the antenna pattern of the portion in which the RFID tag is encapsulated and other factors. If this occurs, adjust
the sensor and set the threshold in the system mode.
For details, refer to “Key Operation Specification”.
5. Cutter
If performing the cut issuance of RFID tag paper, make sure that the antennas and IC chips of RFID tags are not
cut off.
6. Static electricity
If issuing RFID tag paper in a low-humidity environment, for example, use caution because static electricity
generated due to the paper or the ribbon could reduce the data write success rate.
Item
Issue mode
Continuous issuance Peel-off issuance Cut issuance
Media pitch 16.0 to 999.9
(0.63 to 39.37)
25.4 to 152.4
(1 to 6)
25.4 to 999.9
(1 to 39.37)
Media length 13.0 to 997.9
(0.51 to 39.29)
23.4 to 150.4
(0.92 to 5.92)
22.4 to 996.9
(0.88 to 39.25)
Gap/black mark length 2.0 to 10.0
(0.08 to 0.39)
2.0 to 10.0
(0.08 to 0.39)
3.0 to 10.0
(0.12 to 0.39)
Effective print
length
Label 11.0 to 995.9
(0.43 to 39.21)
21.4 to 148.4
(0.84 to 5.84)
20.4 to 994.9
(0.80 to 39.17)
Tag 11.0 to 995.9
(0.43 to 39.21)
– 20.4 to 994.9
(0.80 to 39.17)
Core inner diameter φ38.1 (1.5), φ76.2 (3)
Roll direction Outer roll
To Next Page
Loading...
