Toshiba BV420D - Media Specifications; Media Type and Dimensions

14. Media Specifications 31
14. Media Specifications
This chapter describes the media specifications.
 Media
Make sure that the media to be used is approved by Toshiba Tec Corporation. The warranties do not apply to
problems caused by using media that is not approved by Toshiba Tec Corporation.
For information regarding Toshiba Tec Corporation-approved media, contact your Toshiba Tec authorized
representative.
 Media type
The table below shows the size and shape of the media that can be used on this printer.
[A]: Cut position
[B]: Feed direction
[C]: Black mark (on the back side)
Unit: mm (inch)
1. To ensure print quality and print head life, use only Toshiba Tec Corporation approved media.
2. A label jam is more likely to occur with the approach of label end because labels around the paper core curl
intensely.
Label without black mark Label with black mark
Issue mode
Item
Cut mode
[1] Label width 32.0 to 102.0 (1.26 to 4.0)
[2] Cut length 25.4 to 152.4 (1.0 to 6.0)
[3] Black mark length 6.0 to 10.0 (0.24 to 0.39)
[4] Black mark width Min. 8.0 (0.32)
Thickness 0.06 to 0.19 (0.0024 to 0.0074)
Max. outer roll diameter Ø107 (4.2)
Roll direction Outside wound
Inner core diameter 38.1 (1.5)
[
C
]
[
A
]
[
B
]
[
2
]
[
1
]
[
2
]
[
3
]
[
1
]
[
4
]
[
A
]