Toshiba C3PU35 - Page 64

Chapter 6 Hardware Setup
Computer module C3PU35 User’s Manual
44
Phoenix BIOS Setup Utility
Advanced
I/O Device Configuration Item Specific Help
Serial port A
Serial port B
Parallel port
Floppy disk controller
Base I/O address
[Auto]
[Disabled]
[Disabled]
[Enabled]
[Primary]
F1 Help
↑↓
Select Item -/+ Change Values F9 Setup Defaults
Esc Exit
←→
Select Menu Enter Select
▼
Sub-Menu F10 Save and Exit
I/O Device Configuration screen
Phoenix BIOS Setup Utility
Advanced
Advanced Chipset Control Item Specific Help
8-bit I/O Recovery:
16bit I/O Recovery:
Enable memory gap:
ECC Config:
SERR signal condition:
[4.5]
[4.5]
Disabled
[ECC]
[Multiple bit]:
F1 Help
↑↓
Select Item -/+ Change Values F9 Setup Defaults
Esc Exit
←→
Select Menu Enter Select
▼
Sub-Menu F10 Save and Exit
Advanced Chipset Control screen
(4) If the displayed content is different, correct the setting and perform SAVE & EXIT
(F10) to save the content.
(5) Returning to a setup at the time of shipment is based on the following procedures.
a) Load Setup Default (Exit MENU)
b) Legacy Diskette A: [Disabled] (Main MENU)
c) PS/2 Mouse: [Disabled] (Advance MENU)
d) Exit Saving Changes (Exit MENU)