22
Getting Started
Connect to Canvio AeroCast™
Reset button:
❖ In Wireless LAN mode, press and hold for 5 seconds. The
system will restore to its factory settings.
On/Off button:
❖ Press and hold for 2 seconds: Wireless LAN mode turns ON.
❖ Press and hold for 2 seconds again: Wireless LAN mode
turns OFF.
If the battery is too low, you cannot turn the Canvio
AeroCast™ Wireless Hard Drive ON. The battery
indicator will blink orange for 6 seconds, and then turn
off.
USB 3.0 port:
❖ Compatible with USB 3.0 and USB 2.0.
❖ Allows for data transfer between a computer and the Canvio
AeroCast™ Wireless Hard Drive, when connected.
❖ Allows you to charge the product battery when connected to
the AC adaptor.
Battery Indicator light:
❖ Green: 30% or more available battery power.
❖ Yellow: 10%-30% remaining battery power.
❖ Orange (blinking fast): the product is out of battery power or
the operating temperature is too high. The product will shut
down after 30 seconds.
❖ Green or Yellow (blinking slowly): The battery is charging.
❖ Green (Not blinking): Finished charging.
❖ Green or Yellow (blinking fast): The product is shutting down
or turning ON.
❖ LED Off: The device is powered OFF.
Wireless LAN/HDD indicator:
❖ Wireless LAN Mode
❖ Blue: Wireless LAN is ON (no data access).
❖ Blue (blinking): Wireless LAN is ON (storage access
available).
❖ Blue (turned off): Wireless LAN is OFF.
To Next Page
Loading...
