Toshiba Carrier MMK-AP0073H2UL - Page 125

125
No.
3
Part name
Electric
parts box
Procedure
1. Detachment
1) Carry out works of Detachment of
1
and
2
.
2) Remove the power supply wire and the
remote control wire and control wires from
the terminal blocks.
3) Remove the power supply wire from cord
clamp at side of the electric parts box.
4) Remove screws (M4, 0.39"(10 mm), 2 pcs.))
of the electric parts box and pull out
downward.
5) Hook the hooking section temporarily at the
rear side of the electric parts box to the
sheet fittings part of the main unit.
2. Attachment
1) Insert the square hole of the electric parts
box into the claw of the main unit.
2) Attach screws (M4, 0.39"(10 mm), 2 pcs.))
to the electric parts box.
3) Connect the power supply wire and the
remote control wire and control wires as
before.
4) Carry out works of Attachment of
1
and
2
.
Remarks
U
1
U
2
A
B
L
1
L
2
Cord clamp
Control wiring/Remote
control terminal block
Power supply
terminal block
Cord clamp
Cord clamp
Pull out the cord clamp
Pull out the cord clamp
while pushing
while pushing “
Button
Button”
toward the arrow mark direction.
toward the arrow mark direction.
Screw
Cord clamp
Pull out the cord clamp
while pushing “Button”
toward the arrow mark direction.
Claws of main unit
Hooking sections
pof electric parts boxp
Square hole of
electric parts box
Sheeted folding up
section of main unit