107
No.
6
Part name
Drain cap
Procedure
1. Detachment
1) Carry out work of Detachment of
1
.
2) Loosen screws (3 positions) fixing the drain
cap (outside) and then turn the drain cap to
the arrow mark → (OPEN) direction to
remove it.
NOTE :
The drain cap is hung down because a strap
is attached to it (outside).
3) Loosen the cap by turn the drain cap
(inside) for approx. 1 turn to OPEN →
direction and then drain the drain water
accumulated in the drain pan.
NOTE :
Be sure to catch drain water using a bucket,
etc. when loosening the drain cap.
The insulating materials are adhered to the
drain cap (outside) and opening part of the
drain pan; be careful that they are not come off.
If they are come off, stick them as before
using double-faces tape, etc.
4) Turn the drain cap once again to OPEN
→ direction to remove it.
2. Attachment
1) Insert the drain cap (inside), turn it to the
arrow mark → (CLOSE) direction until the
position where “Clashed sound” is heard
and it cannot be turned more over
(Position where
mark of the drain pan
matches with
mark of the drain cap
(inside)) and then fix it.
NOTE :
When attaching the drain cap (inside),
remove dirt attached to the packing.
And tighten in it noting so that the cap is not
slantingly set.
If attaching the drain cap as dust or dirt is
attached or the cap is set slantingly, water
leakage is caused.
2) Turn the drain cap (outside) to the arrow
mark → (CLOSE) direction and then attach
it using the fixing screw as before.
3) Following to work of Attachment of
1
,
mount the suction grille as before.
Remarks
Replacing antibacterial glass
Request your dealer to replace the
antibacterial glass 10000 hours of
cooling operation.
Part code 43179152
To Next Page
Loading...