109
Remarks
2) Fix the fan motor lead, TC sensor and TCJ
sensor with the clamp of the bell mouth.
3) Mount the electric parts box with the fixing
screws “A and B”.
(M4, 0.39"( 10 mm ), 3 pcs. M4, 0.31"( 8 mm ),1 pc.)
4) Connect the connector, the power supply
wire and the remote controller wire as
before, which were removed in
Detachment work 2) and 3) in previous
page, and then fix wiring with clamp.
5) Following to work of Attachment of
2
,
mount the electric parts box cover and the
suction grille as before.
No.
7
Part name
Fan motor
(Continued)
Procedure
7) Remove the fixing screws and then remove
the bell mouth. (M4, 0.39"(10 mm), 8 pcs.)
8) Remove the fixing screws and then remove
the nut cap. (M4, 0.39"(10 mm), 2 pcs.)
9) Remove the fixing nut and then remove the
turbo fan. (M8 nut with flange, 1 pc.)
10) Remove the fixing screws and then
remove the motor lead holding bracket.
(M4, 0.31"(8 mm), 2 pcs.)
11) Cut the bundling band and then remove it
from the clamp.
12) Remove the fixing nut and then remove
the fan motor. (M6 nut, 3 pcs.)
2. Attachment
1) Fix the parts as before in order of fan
motor → motor lead holding bracket →
turbo fan → nut cap → bell mouth, fan
guard.
NOTE :
Fix the motor lead to the clamp without
slack as before using bundling band.
When fixing the turbo fan, be sure to match
the D-cut of the fan boss with D-cut of the
motor shaft. Using a torque wrench, fix the
turbo fan and tighten in to 4.0 ft
.
lbs(5.4
Nm).
Using torque wrench, fix the fan motor (at 3
positions) and tighten it to 3.6
ft
.
lbs(4.9
Nm).
+0.5
–0.2
+0.4
–0.1
+0.4
–0.2
+0.5
–0.2
Bell mouth
To Next Page
Loading...