High-Wall Type
Installation Manual
–20–
Toshiba
EN
5. Clamp the wired remote controller wire with
the cord clamp.
6. Install the clamp base with a screw.
7. Remove the conduit cover.
8. Attach a conduit to the conduit cover with a
lock nut.
9. Take the Indoor/Outdoor connecting wire
(3 x AWG12 (polar)) and the ground wire
(1 x AWG12) out of the cable slot on the
rear panel so that it protrudes about 11.0”
(280 mm) from the conduit cover.
10.Insert the Indoor/Outdoor connecting wire
(3 x AWG12 (polar)) fully into the terminal
block and secure it tightly with screws.
Tightening torque: 0.12 kgf•m (1.2 N•m)
Secure the ground wire (1 x AWG12) with
the ground screw.
11.Clamp the Indoor/Outdoor connecting wire
with the cord clamp.
12.Attach the conduit cover.
13.Attach the terminal cover, the front panel
and the air inlet grille to the indoor unit.
CAUTION
• Be sure to refer to the wiring diagram attached
inside the front panel.
• Check local electrical cords and also any
specific wiring instructions and limitations.
• Do not catch the wired remote controller wire
when installing the clamp base
• Beware of the metal plate edge when working
on the unit. The edge can be sharp and may cut
your hand.
• Firmly tighten the screws of the terminal block.
Keep the wire length as shown in figure below when
it is connected to the terminal block.
Insert remote controller wires
Conduit Cover
Conduit hole
(dia. 7/8” (22.2 mm))
Conduit hole
(dia. 7/8” (22.2 mm))
Conduit cover
Indoor/Outdoor
connecting wire
Conduit cover
11.0”
(280 mm)
L1 L2 S
Terminal
block for
indoor/
outdoor
connecting
Ground
screw
Ground
wire
Cord clamp
Indoor/Outdoor
connecting wire
0.08” (2 mm) or less
Indoor/Outdoor unit
connecting wire
20-EN
+001111052201_00Ta.book Page 20 Friday, November 20, 2009 11:45 AM
To Next Page
Loading...
