Remote controller with weekly timer
Owner’s Manual
–16–
5. Setting the save operation
Each time the button (38) is pushed, the
numeric display and save operation display
change in the following sequence. Stop
pushing the button when the desired save
operation mode (mode 0 to 3) blinks on the
display.
8 Push the button (42), and enter all
the items in steps I to V above and the
operation time together.
The display of all the setting items changes
from blinking to lighted.
9 In addition:
1. To input the settings into the different
program number for the same day of the
week, repeat the operations from step 4.
2. To move to a different day of the week and
input the program, repeat the operations
from step 2.
10
Finally, push the button (46) to
return to the original screen.
• An underbar is displayed under the
selected day of the week.
Example of setting up an
operation program
Example of program input
For program 01 for Wednesday, “7:00”,
“ON”, “heating”, “77°F (25°C)”, “restriction on
key operation enabled”, “save operation” and
“mode 1” will be set.
• Initial screen (clock setting/operation stop)
Save operation
mode
Description
Mode 0 No save operation
Mode 1
Save operation with 75%
upper limit
Mode 2
Save operation with 50%
upper limit
Mode 3 Compressor shutdown
Mode 0 Mode 1 Mode 2 Mode 3
0
• Push the button (46), and
transfer the display to the input
screen.
• On the input screen, the entire
display blinks.
1
• Push the button (45), and move
the day arrow to the position
above “WE”.
2
• Push the button (42), and enter
the day of the week.
• The days of the week display and
the day arrow stop blinking and
light up.
3
• Repeatedly push the button (37),
and display the number of the
program which is to contain the
settings on the numeric display.
4
15-EN
+00EH99677901_01EN_OM_Remo_Weekly_UL.book Page 16 Thursday, October 8, 2009 2:03 PM
To Next Page
Loading...
