Indoor service monitor list
Code No. Data name Display format Unit
Remote controller
display example
00 Room temperature (Use to control) x1
°F
01 Room temperature (Remote controller) x1
02 Indoor suction air temperature (TA) x1
03 Indoor coil temperature (TCJ) x1
04 Indoor coil temperature (TC2) x1
05 Indoor coil temperature (TC1) x1
06 Indoor discharge air temperature (TF) ** x1
08 Indoor PMV opening x1/10 pls [0150]=1500pls
F9
Suction temperature of air to air heat
exchanger (TSA) **
x1
FA Outside air temperature (TOA) ** x1
D0
Outdoor unit(s) operation level is
lower than capacity command
0 or 1 -
D1
Outdoor unit(s) operation level is
higher than capacity command
0 or 1 -
D2
Cooling oil recovery / Heating
refrigerant recovery control
0 or 1 -
D3 Cooling operation output 0 or 1 -
D4 Heating operation output 0 or 1 -
D5
The suction air temperature (TA) is in the
thermostat OFF range (only TF type)
0 or 1 -
DF
Under restriction of compressor speed due to
heat sink overheating in outdoor unit (s)
0 or 1 -
F5 Tx temperature x1
0A No. of connected indoor units x1 unit [0048]=48 units
0B Total horsepower of connected indoor units x10
Ton [0415]=41.5Ton
0C No. of connected outdoor units x1 unit [0003]=3 units
0D Total horsepower of outdoor units x10
Ton [0420]=42Ton
Indoor unit data
[0024]=75°F(24°C)
[0024] = 75°F(24°C)
0=No output
1=Output
System data
°F
°F
°F
°F
°F
°F
°F
°F
°F
To Next Page
Loading...
