Before Calling Service Personnel
Before calling_service personnel, please check the following chart for a possible cause of the problem you are experi-
encing. A minor adjustment on your part may eliminate the problem and restore your TV reception.
• No sound, picture OK
• Poor picture, sound OK
Snowy picture
Lines in picture
Distorted picture
Weak picture
• Poor reception of broadcast
channels
channel
• Multiple images (ghosts)
• Poor color or No color
• No stereo or SAP sound from a
known MTS broadcast
• Remote Co_etrol does not work
• Be sure power cord is plugged in.
• May be station trouble
• Check antenna connections.
• Check antenna for broken wires.
• May be station trouble.
• Check if SPEAKERS ON/OFF function (page 35) is
properly set.
• May be station trouble.
• Check antenna connections.
• May be local interference from appliance.
• May be local interference from appliance.
• Check antenna connections.
• Check antenna for broken wires.
• May be station trouble.
• Check antenna connections.
• Check antenna for broken wires.
• If VCR is connected, check TV/VCR switch.
• Be sure TV/CABLE function (page 15) is'in "TV"
mode.
• That channel may be locked out with CH LOCK
function (page 28), or erased with the ADD/
ERASE function (page 16 ).
• May be station trouble.
• Check antenna connections.
• May be station trouble.
• Check antenna connections.
• Check antenna for broken wires.
• May be local interference from appliance.
• Check if station is broadcasting in color.
• If you change the direction of the TV while the TV
is activated, the picture may suffer from color
shading. If so, turn off the TV and allow to cool
for about 30 minutes, _hen turn on the TV again.
The picture should improve.
• Check if MTS function is properly set.
• Check if -IV-CABLE-VCR switch is properly set.
• Be sure power cord is plugged in.
• Check battery in Remote Control.
• Press POWER button.
• Try another channel.
• Try another channel.
• Adjust VOLUMI
• Try another chz
• Adjust VOLUMI
• Adjust BASS, T]:{EBLE, or
BALANCE cont
• Re-orient antenna.
• T:ry _nother channel.
• Adjust BRIGHTI
• Adjust CONTR!
• Adjust SHARPI _
• Re-orient antenna.
e_ry another channel.
• Re-orient anten
• Try another ch_nnel.
• Re-orient antenna.
• Try another ch_mnel.
• Re-orient antenna•
• AdjLi_StTINT.
• Adjust COLOR.
• Change batteri "-
38
To Next Page
Loading...
