Dubbing/Editing Video Tapes Using 2 VCR's
To dub or edit your own video tapes between one VCR and another, connect the VCR that will play to the input jacks
(VIDEO 1 or VIDEO 2) on the "IV. Then connect the output jacks on the back of the TV to the input jacks on the recording
VCR.
Note: Do not connect one VCR to the output and input jacks on the back of the TV at the same time.
Back of TV
Video
output
4_ Audio
outputs
VCR for playback
VIDEO1 VIDEO2
S-VIDEO
ANT
(75_)
Audio
inputs
Video
input
1
2
Turn the TV and both VCR's on.
Press the W/VIDEO button to select "VIDEO 1" (or
"VIDEO 2" depending on which input jacks are used
for connecting the VCR for playback).
TV
VIDEO 1
VIDEO 2
TO SFiECT PiS_ _' ViOEO
3 Set the VCR for recording to record mode and the
VCR for playback to playback mode.
4 You can view the video tape from the VCR for play-
back on the TV screen while dubbing it with the VCR
for recording.
VCR for recording
CAUTION:
The unauthorized recording of television programs,
video tapes and other materials may infringe upon the
provisions of copyright laws.
Notes:
• The input switch of the VCR is normally in the TV
position.
Change the input switch of the recording VCR to the
external input position such as LINE or CAMERA when
using the video/audio inputs of the VCR as above.
Some VCR's automatically switch when the cables are
plugged into the video/audio inputs.
• The PIP picture cannot be output from the VIDEO OUT
"jack.
• The "fixed level" audio signal through the AUI_IO jacks
of OUT jacks is also ideal for connect=q1"gan'audio
cassette recorder (or amplifier) to record sound from
the "IV. This constant audio signal is not affected by
pressing the VOLUME _ buttons.
To Next Page
Loading...