Station
Assignment
Strata CTX Programming - Part 2: CTX WinAdmin Programming 11/03 5-11
Station
23 Mail Box Selection Select the method to enter the destination Mailbox for Call Recording. If set to
“Auto” CTX uses the VM ID of the station initiating the record function.
Notes
• The DN assigned as the MSG center in PROG 200 is used to call the VM port or
Hunt group (PROG 200 FK 22).
• When set to “Auto” the VM-ID of the station initiating the record function is sent
to Stratagy ES as the destination mailbox.
• When set to “Manual Input” the user may enter any valid Mailbox followed by
the “#” sign. If the user Presses “#” without additional data the CTX will send the
VMID of the originating station.
Possible values: Auto or Manual (default)
24 MIC Init. Value Turn on the microphone automatically when making a speaker phone call.
Note The microphone must be enabled.
Possible values: On (default) or Off
25 Microphone Enable microphone.
Possible values: Enable (default) or Disable
26 Speaker Mode
Tones
Enable telephone to receive Call Waiting (Camp-on) and Ring Over Busy Tone
while on a speaker phone call.
Possible values: Yes (default) or No
27 Ring Over Busy
Cycles
Set ROB to ring two times or continuously.
Possible values: Two Cycles or Continuous (default)
Note See PRG200, 26 to enable ROB to be sent to individual telephones.
28 Attd Overflow Dest. Select overflow destination for attendant.
Possible values: Up to 32 ASCII characters (default = none)
29 Trunk Test and
Verify
Allow Trunk Tests and Verification.
Possible values: Yes or No (default)
30 Auto Line Hold Enable Automatic Line Hold. This parameter allows a station to “line hop” from one
call to another automatically by placing the first call on hold.
Possible values: Enable or Disable (default)
32 Programming Mode Enable: Allows the telephone to enter the Programming Mode. Disable: Restricts
the telephone from entering the Programming Mode. This parameter is available
only with Strata CTX Release 2.0 MF017 and higher.
CAUTION! Since we added this parameter, you cannot downgrade to
previous versions of CTX because we do not support
downward compatibility of CTX database. If you attempt
downgrading, the entire Program 204 will be lost. Toshiba
recommends keeping the current database for emergency
situations. We guarantee upward compatibility of the database,
so you can upgrade the system without any problems.
Possible values: Enable (default) or Disable
FIELD DESCRIPTION
To Next Page
Loading...
