Toshiba CTX100-S - Page 172

Trunks
ISDN
6-22 Strata CTX Programming - Part 2: CTX WinAdmin Programming 11/03
1. This command assigns ISDN BRI
Trunks.
1. Complete the “ISDN BRI Station
Record Sheets” on page D-19. From
the Program Menu, click Trunk >
ISDN > BRI.
2. Enter Channel Group number
...or click one of the following
buttons:
• List – view a summary list of
programmed Trunks.
• Create – Assign a new Trunk
with default settings.
• Copy – Enter a Channel Group
number and click Copy to make a new Trunk assignment with settings copied from the Channel
Group you entered.
• Delete – Delete an Trunk.
3. Enter data.
4. Click Submit.
FIELD DESCRIPTION
Channel Group Enter the BRI channel Group Number.
Possible values: 1~32 (CTX100), 1~48 (CTX670 Basic), 1~128 (CTX670 Exp),
(default = no value)
01 Equipment Number Enter the equipment number xxyyzz to which the ISDN BRI Trunk is to be assigned.
Example: If the RBUU is installed in cabinet shelf 5, slot 3, enter 050301 for circuit 1.
Possible values: xx = Cabinet 01~07; yy = Slot 01~10; zz = Circuit 01~08 or 01~24
(CTX670)
xx = Cabinet 01; yy = Slot 01~08; zz = Circuit 01~04 (CTX100)
(default = no value).
Cabinet numbers:
• CTX100 – Select 01 for Base and Expansion cabinet.
• CTX670 – Select 01 for Base and 02~07 respectively for each Expansion cabinet.
Slot numbers:
• CTX100 – Select 01~04 for Base slots and 05~08 for Expansion slots.
• CTX670 – Select 01~08 for Base slots and 01~10 for Expansion slots.
02 Protocol Select the ISDN protocol. Only Bearer capabilities specified by the protocol can be
entered in this field. The Initial value for ISDN Protocol corresponds to information set
in the hardware level.
Possible values: Nat’l ISDN (default), ETSI, TTC or Nat’l ISDN Nortel
National ISDN = North America, ETSI = England and TTC = Japan.