Services
Strata Net QSIG Over IP
Strata CTX Programming - Part 2: CTX WinAdmin Programming 11/03 9-61
Services
Strata Net QSIG Over IP
To use programs 671 and 672, refer to “Strata Net over IP Programming Guidelines” on page A-13.
671 IP Address Convert Table
1. From the Program Menu, click Services
> Networking > Network Over IP.
2. Enter Program 671 data.
3. Click Submit.
FIELD DESCRIPTION
Remote Node ID Enter the Node ID of the remote CTX that the primary CTX should route to in
the IP Private Network.
Possible values: Up to six digits.
01 BIPU-Q IP Address
Route 1
Enter the IP Address of the remote BIPU-Q IP that should be routed to first.
Possible values: 0~255
02 BIPU-Q IP Address
Route 2
Enter the IP Address of the remote BIPU-Q IP that should be used if all
channels in the first BIPU-Q route is busy or disabled.
Possible values: 0~255
03 BIPU-Q IP Address
Route 3
Enter the IP Address of the remote BIPU-Q IP that should be used if all
channels in BIPU-Q Route 1 and 2 are busy or disabled.
Possible values: 0~255
04 BIPU-Q IP Address
Route 4
Enter the IP Address of the remote BIPU-Q IP that should be used if all
channels in BIPU-Q Route 1, 2 and 3 are busy or disabled.
Possible values: 0~255
05 BIPU-Q IP Address
Route 5
Enter the IP Address of the remote BIPU-Q IP that should be used if all
channels in BIPU-Q Route 1, 2, 3 and 4 are busy or disabled.
Possible values: 0~255
06 BIPU-Q IP Address
Route 6
Enter the IP Address of the remote BIPU-Q IP that should be used if all
channels in BIPU-Q Route 1, 2, 3, 4 and 5 are busy or disabled.
Possible values: 0~255
To Next Page
Loading...
