Toshiba CTX100-S - Page 361

Telephone Button Programming
200 Series Programs
Strata CTX Programming - Part 3: Telephone Button Programming 11/03 13-47
Telephone Button
Programming
213-01 Key Number
)% ~ )%
Press the desired FB to program.
Code
n,
6SNU
n = 1~20 Select Desired Feature Code. See the Feature Code Table 13-22 on
page 41.
100 - PDN
110 - PhDN
120 - CO
130 - GCO
140 - Pooled Line Button
540 - Door Lock Cancel
560 - PhDN Message Waiting
610 - DSS Button
900 - Start Application
Parameter 1
n1, see Note
Note For Feature
Code 560,
610 and 900,
make your
selection and
push
6SNUIRU
IXUWKHU
RSWLRQV
.
n1 = See “Flexible Button
Assignment Feature Code
Table” on page 13-41 and
“Feature/Button Code
Parameter Assignments”
on page 13-40 for more
details.
This Parameter is required for all Feature Codes.
Parameter 2
n2, see Note
Note For Feature
Code 100,
make your
selection and
push
6SNUIRU
IXUWKHU
RSWLRQV
.
n2 = See “Flexible Button
Assignment Feature Code
Table” on page 13-41 and
“Feature/Button Code
Parameter Assignments”
on page 13-40 for more
details.
This Parameter is required for all Feature Codes except Feature
Codes 560, 610 and 900.
Parameter 3
n3,
 see Note
Note For Feature
Code 110 and
140, make
your selection
and push
6SNUIRU
IXUWKHU
RSWLRQV
.
n3 = See “Flexible Button
Assignment Feature Code
Table” on page 13-41 and
“Feature/Button Code
Parameter Assignments”
on page 13-40 for more
details.
This Parameter is required for Feature Codes 110, 120, 130 and 140
only.
Parameter 4
n4, see Note
Note For Feature
Code 120,
make your
selection and
push
6SNUIRU
IXUWKHU
RSWLRQV
.
n4 = See “Flexible Button
Assignment Feature Code
Table” on page 13-41 and
“Feature/Button Code
Parameter Assignments”
on page 13-40 for more
details.
This Parameter is required for Feature Codes 120 and 130 only.
Parameter 5
n5, see Note
Note For Feature
Code 130,
make your
selection and
push
6SNUIRU
IXUWKHU
RSWLRQV
.
n5 = See “Flexible Button
Assignment Feature Code
Table” on page 13-41 and
“Feature/Button Code
Parameter Assignments”
on page 13-40 for more
details.
This Parameter is required for Feature Codes 130 only.
Table 13-25 Programs 208~218 (continued)
Button Sequence Value(s) Summary