Telephone Button Programming
300 Series Programs
Strata CTX Programming - Part 3: Telephone Button Programming 11/03 13-69
Telephone Button
Programming
319
Intercept Treatment
,
+ROG
This command assigns Intercept positions for Strata CTX Day/Night
schedules. Intercept positions are used when the destination of a
trunk line call is not determined with DID or DIT
319-00 Tenant Number n = Enter 1~8 Select the Tenant number for which the Intercept Destinations will be
configured.
01
02
03
Day1 Destination
Day2 Destination
Night Destination
)%
~
)%
, n,
6SNU
,
n1,
+ROG
,
+ROG
n = 1. None (default)
2. Dialing Digits
3. Night Bell
Select Destination Type for each.
n1 = Up to 32 digits Enter Destination for each.
• To intercept with a DN use 0~99999
• To intercept with a Network DN use 1~32
• To intercept with Dial Digits Paging 1~16
320
B Channel
,
+ROG
PRI interfaces are purchased on per interface and channel basis. The
‘B’ channel assignments allow for a flexible activation of channels to
match the subscribed services from the Public Service Telephone
Network.This command allows you to enable or disable each B
channel on selected RPTU PCBs.
320-00 RPTU Equipment No.
xxyyzz,
+ROG
xx =
yy =
zz =
xx = cabinet 01
yy = 03, 05, or 07
zz = Channel 01 is always
used to assign RPTU
parameters
Enter the ISDN RPTU equipment number.
Equipment numbers are required when assigning ISDN RPTU
parameters in the system. It can also be used to display the
equipment location of existing RPTU PCBs.
Example: If the RPTU is installed in cabinet shelf 5, slot 3, enter
050301.
or
xx = cabinet 02~10
yy = 01, 03, or 05
zz = Channel 01 is always
used to assign RPTU
parameters
320-
01~23
B Channel
)%
~
)%
, n,
+ROG
,
+ROG
n = 1. Enable (default)
2. Disable
Assign each ‘B’ channel as enabled or disabled for each channel on
the interface. The assignments must match exactly to the
subscription from the PSTN.
Table 13-31 Programs 318~320 (continued)
Button Sequence Value(s) Summary
To Next Page
Loading...
