Toshiba CTX100-S - IP Telephone Update

Software and Firmware Updates
IP Telephone/BIPU Firmware Update Procedures
E-6 Strata CTX Programming - Part 4: Appendices 11/03
11. Press the BIPU reset button for proper initialization.
IP Telephone Update
Important! Complete all “Prerequisites” on page E-4 before you do the following.
➤ Copy the DIPXXXX file into the WinAdmin PC CTXIPUPDATE directory.
Notes
● The directory location should be C:\Ctx\W inAdmin\CTXIPUPDATE The drive letter must be
the drive on which WinAdmin is installed.
● (XXXX in the DIP file name is the firmware version level of the IP telephone).
➤ From the WinAdmin PC perform the update
Important! The BIPUs and IPTs will automatically be disabled while Update takes place and return to
the idle state when Update is complete (if they were in the idle state when the Update was
started).
1. Select IP Telephone > IPT Program Update.
2. Select the IPT PDN(s) to be updated.
3. Select Local WinAdmin (radio button).
4. Enter the Windows user login Name and Password.
Note If in doubt, create a new Window logon User Name and password and use it in Step 6.
5. The IP address of the WinAdmin PC is inserted automatically.
6. Data Directory will be: CTXIPUPDATE
7. From File Name drop down box select: DIPUXXX
8. Click Start and observe the update status: Getting Updated file\Updating\Finished
Updating\Resetting\idle.
Notes
● It could take 30 seconds to 2 minutes to update the IP telephone
● If an error occurs, recheck file names, locations etc. and try again.
9. Select IP telephone > Station Data. Check the IPT version number to verify that all IPTs have been
updated properly.
10. To check the IP telephone firmware version directly from an IP telephone.
• Simultaneously press the
+ROG buttons on the IP Telephone.
• At the SELECT = prompt, press
 then press +ROG.
• At the Select function key prompt, press
)%, the IP telephone will be displayed.
• To exit this mode, go off and on hook.
Notes
● The WinAdmin PC cannot be connected directly to the CTX processor network jack.
● All connections must be through the network.