Software and Firmware Updates
IP Telephone/BIPU Firmware Update Procedures
E-8 Strata CTX Programming - Part 4: Appendices 11/03
➤ From the WinAdmin PC perform the BIPU update
Important! The BIPUs and IPTs will automatically be disabled while Update takes place and return to
the idle state when Update is complete (if they were in the idle state when the Update was
started).
1. Select IP Telephone > BIPU Program Update.
2. Select the BIPU card slot and BIPU-M card type.
Note Only BIPU-M can be updated. Only BIPU-M card slots will be shown with WinAdmin 2.1F or
higher. The BIPU type selection is not required.
3. Select Other (radio button).
4. Enter the ftp user login Name and Password.
5. Enter the IP address external ftp server.
6. From Data Directory box enter: CTXIPUPDATE
7. From File Name box enter: BIPUXXX
8. Click Start and observe the update status: Getting Updated file\Updating\Finished
Updating\Resetting\idle.
Notes
● It could take 1 to 5 minutes to update the BIPU
● If an error occurs, recheck file names, locations etc. and try again.
9. After the update is complete, select IP Telephone > BIPU Configuration. Check the BIUP version
numbers to verify they have been updated properly.
10. Press the BIPU reset button for proper initialization.
IP Telephone Update
Important! Complete all “Prerequisites” on page E-7 before you do the following.
➤ Store the IP update files on the external ftp sever
1. Create an ftp directory and name it CTXIPUPDATE
2. Copy the DIPUXXXX update files to CTXIPUPDATE directory (XXX is the BIPU firmware version
level).
➤ From the WinAdmin PC perform the update
Important! The BIPUs and IPTs will automatically be disabled while Update takes place and return to
the idle state when Update is complete (if they were in the idle state when the Update was
started).
1. Select IP Telephone > IPT Program Update.
2. Select the IP PDN to be updated.
3. Select Other (radio button)
4. Enter the external server ftp user login Name and Password.
5. Enter the IP address external ftp server.
6. From Data Directory box enter: CTXIPUPDATE
To Next Page
Loading...
