System
105 System Data
4-14 Strata CTX Programming - Part 2: CTX WinAdmin Programming 11/03
21 Primary Clock
22 Secondary Clock
Enter data as xxyyzz.
zz=channel 01 if clock source is RPTU or RDTU
zz=channel 01, 02, 03 , or 04 if clock source is RBUU/RBUS or RBSU
Example: If the Primary Clock Source should be a assigned to an RPTU in cabinet
5, slot 2, enter 050201.
Cabinet numbers:
CTX100: Select 01 for Base and Expansion cabinet.
CTX670: Select 01 for Base and 02~07 respectively for each Expansion cabinet.
Slot numbers:
CTX100: Select 01~04 for Base slots and 05~08 for Expansion slots.
CTX670: Select 01~08 for Base slots and 01~10 for Expansion slots.
23 Call History Prefix 1 Add the dialing prefix 1 when using the callback feature in Call History.
Possible values: Add (default) or Do Not Add
24 Emergency Digits Sent Enter an alternative emergency dialing string. If no value is entered in this field any
previously programmed value is overwritten.
Possible values: Up to 5 digits (default = 911)
25 DP Make Ratio Select the Dial Pulse Make/Break ratio.
Possible values: 33% (default) or 40%
26 Call Button Jumping Select whether to execute Jumping LED.
Possible values: Enable (default) or Disable
• If enabled, line calls move from a telephone DN button to a line button after they
are answered. After answering the call, the DN button is cleared to receive
another call.
With Call Jumping, the DN acts as an Answer button. This only applies if the line
that is answered has a CO/GCO/Pooled button appearance on the telephone.
• If disabled, line calls remain on the DN after they are answered.
39 Std. Tel. Ringing
Cadence
Select the Ringing Cadence for Standard Telephone circuits. This parameter is
available only with CTX WinAdmin R2.1 and above.
Note This does not apply to Digital to IP telephones.
(Ringing Type1)
External Ring:20Hz, 1sec. ON - 3sec. OFF
Internal Ring:20Hz, 0.4sec.ON - 0.2sec. OFF
- 0.4sec. ON - 3sec. OFF
Recall:20Hz, 1sec. ON - 1sec. OFF
(Ringing Type2)
’Ringing Type2’ is the same Ringing Cadence as DK.
External Ring:20Hz, 0.4sec. ON - 0.2sec. OFF
- 0.4sec. ON - 3sec. OFF
Internal Ring:20Hz, 1sec.ON - 3sec. OFF
Recall:20Hz, 1sec. ON - 3sec. OFF
41 CSTA B-Ch. Operation Enabled - CSTA shall provide full ’B’ Channel path information. Disabled - CSTA
shall provide channel group only.
Possible values: Enable (default) or Disable
FIELD DESCRIPTION
To Next Page
Loading...
