Toshiba CZ19M21 - Page 17

If you tryto watch a TV program that
exceeds the rating limits you set, the
TV will enter into the program block
mode.
THrS pR(]GR_MHAS BEEN BL_KED
TV-PG L V
E×CEEDS SET LrMfTS
PUSH MJTE TO _TER pIN
CABtE 4
2 If you want to watch the blocked
program temporarily, press MUTE.
Press the Number
buttons (0-9) to BLOCKINGISACTIVE
PLEASE ENTER PIN CGOE
enter the 4-digit TOTE_A,,_YU,.,L_
code you have
stored.
If the number is SELECt[O-_IE_{EX,T_
correct, the block
mode will be released.
After 1 second, a normal picture will
appear.
All blocking is disabled until the "IV is
turned off.
It will be enabled when the power is
reapplied.
Ifa wrong pin code
is entered, the
"Incorrect pin code"
message appears.
Enter the correct
code again.
INCORRECT ptN C_CE
PLEASE ENTER PIN OOOE
TO TEMPO_q_Ly UN.BLOCK
H**
SELECT[O-g) END[EIITJ
With the CHANNEL BLOCK function, you
can block specific channels. The TV will
not be able to tune these channels with
the CHANNEL _ buttons or Channel
Number buttons, unless you clear the
setting.
This TV has 8 memory spaces total, 4 for
TV mode and 4 for CABLE mode.
To block channels
1 Select a channel you want to block.
Select"BLOCK I
CHANNEL" in I _,_,_T_,._,_:_'_....
,_Er 6LC-CKING OpT_O_
the V-CHIP I
CONTROL menu I _=o_CH,"EL
by pressing
• or A. _OVEt*v] SELECT[_t,I
4
5
6
Press <1or • to
display the BLOCKCHANNEL
• SET CLEAR
BLOCK 0 0 0 0
CHANNEL
menu, SELECTI4 I. ) SET[& • I
END/EXIT I
Press < or •
to select "SET". I _L=_C_,_L
then press • •_T C_EA,0
or • until the I
channel number
to be blocked E"O_X'TIS_LECT[_,I SETI,,]
( 2 nths
example) replaces "0" on the displa_
Repeat steps 1 to 4 for other
channels.
Select another channel before turning
off the TV.
To restore channels
1
2 Press • or •
until "O" re-
places the
channel
numbers.
Select "CLEAR" following the above
steps 2 to 4.
BLOCK (_4ANNEL
SET•CLEAR
/
SELECTI4 • ]ISET[& • ]
END[EXIT I
!
mmmmmmmm
3 Press EXIT to erase the display.
17