Toshiba CZ27T31 - Using V-CHIP Control

Using V-CHIP Control
Some TV programs and movies include signals that classify the content of the program (violence, sex, dialog, language).
The V-CHIP Control feature in this TV detects the signals and blocks the programs according to your selections.
To use this feature, perform the following setup.
_ECALL MUTE
RECAL,---'0 (
®®®
® ®e
MENU- !4_
TOSHIBA
To return to the normal picture
PressEXIT.
--Number
buttons
--vii
-- EXIT
Selecting the V-CHIP CONTROL menu
1 Press MENU then • or • repeatedly until
"V-CHIP CONTROL" in the Set up menu
is displayed in purple.
2 Press • orl_ to display the pin code
entering mode.
• Factory reset status
Set your 4 digit code by pressing the
Number buttons (0-9).
Example: To enter "1110"
Press 1, 1, 1,and 0 in order.
• When the pin code is already stored
Press the Number buttons (0-9) to
enter the 4-digit pin code used to
block channels.
lfa wrong pin code has been enterd
The message will appear. Try to enter the
correct code again.
If you can not remember the pin code you
have stored, while in the pin code entering
mode, press the RECALL button four
times within 5 seconds.
The pin code you have stored will be
released. (Factory reset status).
After about 1 second, the semen changes
to the V-CHIP CONTROL menu as
shown.
Continue to set each item following the steps
on the next page.
¥._d_ CO_TgOt
IIOVEI& T] START[4 _,1
8LOCKI_ _$ RESET I
PLEASE ENTER NEW PIN I_E
1110
SELE_T(0-9] ENO[EXIT]
8L_ING IS ACTIVE
PL[ASE E_ER PIN GI_E
1234
SELEGT[O-I] ENDIEXIT ]
I_JI_RECT PIN _
PLEASE ENTER pI_ _
1235
SELECT[O-_] END[EXIT]
ENABLE BLOCKING Y[NI
SET RATING
SET BLOCKING O_T]O_S
_ pIN C(_O_
BLOCK CHAMt_ L
I_OVEI& v I SELECT[,I e.}
9,1