Power requirement during operation
Power requirement at standby
Power supply
Mass
External dimension
Incoming channels
Antenna input/output terminal
Signal system
Laser
Format
Image recording system
Sound recording system
VIDEO input
VIDEO output
S-VIDEO input
S-VIDEO output
COMPONENT output(Y, P
B
, P
R
)
AUDIO input
AUDIO output
DIGITAL AUDIO OUTPUT BITSTREAM/PCM
(OPTICAL terminal)
HDMI output
DV input
Remote control
Operating conditions
Clock display
Clock accuracy
22W
1.3W
120V AC, 60 Hz
3.5kg
Width 430 x Height 62 x Depth 302mm
TV : 2-69CH, Cable : 1-125CH
VHF/UHF : 75Ω, RF Connector
Standard NTSC Color TV system
Semiconductor laser, Wavelength : 650nm/780nm
DVD -VR format
DVD-Video format
MPEG2
AC 3
1.0Vp-p (75Ω), Sync signal negative, Pin jack x 2 systems, 1 at rear, 1 in front
1.0Vp-p (75Ω), Sync signal negative, Pin jack x 1 system, 1 at rear
(Y) 1.0Vp-p (75Ω), Sync signal negative,
(C) 0.286Vp-p (75Ω) 1 at rear, 1 in front
Mini DIN4 Pin x 2 systems
(Y) 1.0Vp-p (75Ω), Sync signal negative,
(C) 0.286Vp-p (75Ω) 1 at rear
Mini DIN4 Pin x 1 system
Y output (green), 1.0Vp-p (75Ω), Sync signal negative, Pin jack x 1 system
P
B
, P
R
output (blue, red),
0.7Vp-p (75Ω), Pin jack x 1 system each
2.0V (rms), 22kΩ or above, pin jack (L, R) x 2 systems
1 at rear, 1 in front
2.0V (rms), 2.2kΩ or below, pin jack (L, R) x 1 system
2 at rear
Optical connector x 1 system
This is for connection of an HDMI cable
4-pin x 1 in front
Wireless remote control (SE-R0218)
Temperature: 41°F~95°F (5°C~35°C)
Position: Horizontal
12 hour digital display
Quartz (monthly deviation: approximately ±30 seconds)
SPECIFICATIONS
• The design and specifications may change without prior notice.
• The Illustrations and screens described in this manual may be exaggerated or simplified for easy recognition and may be slightly different from the actual unit.
To Next Page
Loading...
