Toshiba D-VR16SB - Preparation of the remote control (contd); VCR; DVD recorder Switching

Introduction
22 EN
Preparation of the remote control (cont’d)
Because this product is a combination of a VCR and a
DVD recorder, you must first select which component
you wish to operate with [VCR/DVD] on the front panel.
VCR mode
Press [VCR] on the remote control.
(Verify that the VCR indicator is lit.)
DVD mode
Press [DVD] on the remote control.
(Verify that the DVD indicator is lit.)
Notes:
• Pressing only [VCR/DVD] on the front panel DOES
NOT switch the mode of the remote control. You
MUST select the correct mode on the remote control.
• Press [VCR/DVD] to select the DVD mode or the VCR
mode.
• You cannot switch to the mode (DVD or VCR) that is in the
timer-standby mode.
• If the media is available, you can start recording by
pressing [REC I] (DVD) or [REC I] (VCR) on the remote
control even if another equipment (DVD or VCR) is
selected. In this case, the mode of the remote control will
be automatically switched to the appropriate component.
VCR / DVD recorder Switching
ON / STANDBY
VCR
REC DUBBING
PROGRAM
VCR/DVD REC
DVD
DVDVCR
VCR/DVD
DVDVCR
DVD indicator
VCR indicator
02IntroductionBD.indd2202IntroductionBD.indd22 2006/03/2414:35:522006/03/2414:35:52