66 - English
Recording
While a recording is in progress, you can watch a differ-
ent channel, watch a different media, or add recording
time. (see page 61)
1
Watch a different channel
When a TV is connected with an antenna cable only,
press TV/VCR to select the TV position. Change the
channel by using the TV Channel Selector.
When a TV is connected through AV input during
recording, change the input of your TV from AV to
Antenna. Select the channel you want to watch.
2
Watch a different media during recording
You can watch a DVD during VCR recording or
watch a Video tape during DVD recording.
• During VCR recording, insert a DVD in the DVD
deck. The output will automatically change to the
DVD and start playback.
• During DVD recording, insert a Video tape in the
VCR deck. The output will automatically change
to the VCR and start playback. (Only if tape is
missing the safety tab)
3
Add recording Time
Refer to the One-Touch Recording (OTR).
(See page 62)
4
Recording DVD and VCR at the same time
You can record DVD and VCR at the same time,
but both modes must be set up to record separately.
• Press the DVD or VCR button to set the unit to
DVD or VCR mode respectively.
• Choose AV input mode (PR, AV1, AV2 or Aux). for
DVD or VCR.
• Choose REC SPEED mode for DVD or VCR.
• Press REC button for DVD or VCR.
Special Recording
Features
When DVD Recorder & VCR is connected to
your TV using S-Video or component video
cable, the playback screen on the video tape
will not display during DVD recording.
You cannot record different channels at the
same time, however you can record from differ-
ent input source at the same time.
The DVD and VCR cannot start recording at
the exact same time. You must set one mode to
start recording, then the other.
Note
4
Press the (REC) button on the remote control or
front panel.
For options while recording is in progress, see
“Special Recording Features”.
5
Press the STOP button to stop or finish a record-
ing in progress.
When you watch or record on the VCR during
DVD Recording, some function buttons may not
operate.
The message “This function is not available.” will
be displayed.
Note
Maximum Recording Time - SP vs. LP
Tape Length Recording Time (in SP)
E180 180 mins or 3 hours
E240 240 mins or 4 hours
E280 280 mins or 4 hours and 40mins
E300 300 mins or 5 hours
1
Press DISPLAY button on the remote control.
Following information will be displayed.
(Current deck status, recording speed, remaining
time, input mode, current time.)
Check Remaining Time
RAM
Stop/Stop
0:00:02
SP
Rem 06:07
AV 2
VCR
Stop
0:00:03
SP
Rem 05:41
PR 1
Sat 22 Jan. 2005 14 : 01
❚
Pausing / Resuming
• Press the REC PAUSE button to pause a recording
in progress.
• Press the REC PAUSE button again during pause to
resume recording.
• You can switch programme by pressing the
PROG/TRK (
/
) buttons while recording pauses.
VR25SB-2-eng 5/6/05 5:43 PM Page 66
To Next Page
Loading...
