Dispose of batteries according to local environmental reg-
ulations. Do not put them in the household trash.
Install Batteries in the Remote Control
•
Open the battery cover on the back of the remote.
• Insert two AA batteries. Make sure that the polarities
(+ and -) are aligned correctly.
•
Replace the battery cover.
If remote does not operate properly:
•
Check the polarity + - of the batteries (Dry-Cell)
•
Check if the batteries are drained.
•
Check if remote sensor is blocked by obstacles.
•
Check if there is any fluorescent lighting nearby.
Step 7 : Preparing the
Remote Control
•
Do not expose the remote sensor of the recorder to a
strong light source such as direct sunlight or other illu-
mination. If you do so, you may not be able to operate
the recorder via the remote control.
To determine whether your television is
compatible, follow the instructions below.
1. Switch your television on.
2. Point the remote control towards the television.
3. Hold down the TV button and enter the four-figure
code corresponding to the brand of your television,
by pressing the appropriate numeric buttons.
To Next Page
Loading...
