Toshiba D-VR600 - ZERO RETURN function; Video index search system; ZERO RETURN function; Video index search system; Index search

Tape playback
47
ZERO RETURN function / Video index search system
8 : 47AM MON
00 : 04 : 38 SP
HI-FI
00 : 00 : 00 SP
HI-FI
8 : 47 AM MON
CH 001
INDEX
1
Press DISPLAY.
The counter display shows the tape run-
ning time during playback or recording.
2
Press COUNTER RESET at the desired
tape position. The counter display will be
reset to the “00:00:00” position (e.g. the be-
ginning of recording).
3
Press STOP when playback or recording is finished.
Press ZERO RETURN.
The tape will be rewound or fast forwarded and automatically stop
at the “00:00:00” position.
Switching the display between clock and counter
Press CLOCK/COUNTER. The clock and tape counter alternate with
each other in the display window.
Video index search system
This function enables you to locate the beginning of any record-
ing made on the VCR.
Recording an INDEX MARK
The Index search function automatically records
an INDEX mark on the tape whenever a record-
ing is initiated.
Index search
Press INDEX 7 or 6 during stop or play
mode.
For Succeeding programs: Press INDEX 7.
For Preceding programs: Press INDEX 6.
(Additional press increases the INDEX NO.
up to 9.)
When the INDEX 7 or 6 is pressed, the
unit starts searching the INDEX NO. selected
and finds the portion, then playback starts
automatically.
To stop the Index Search, press STOP.
ZERO RETURN function
This function makes tape rewind-
ing stop at the counter “00:00:00”
position automatically.
P
SP
P
PM
SP
NOTES for Counter Display:
• If you rewind the tape beyond
“00:00:00”, a minus sign (“–”) will be
displayed in front of the time.
• When you load a tape, the counter
will reset to “00:00:00”.
• The counter does not function on
non-recorded (blank) sections of the
tape. When you rewind, fast forward
or play tapes through blank sections,
the counter stops.
NOTES for Video index search sys-
tem:
• When you record an INDEX mark
at the very beginning of the tape, the
mark may not be found.
• During INDEX search, the tape may
stop and begin to play at a slightly
different location.
• INDEX may not function properly
with old or worn out video tapes.
• INDEX marks may not be found if it
is extremely close to the point where
the search began.
• In recording, if you stop recording
temporarily, the INDEX mark is not
recorded on the tape.
7 or 6 is displayed
+3
INDEX NO. (up to 9)
2K70101A_E P44-51 08`02`07, 20:4547