e-STUDIO160/200/250 DEVELOPER UNIT 12 - 8 December 2002 TOSHIBA TEC
084
083
082
RELAY PWA
Front cover
CN39
CN32
CN54
Clamp
Side cover
Screw
Screw
Screw
DEV. motor assembly
Fig. 12-6-1
7. If an ADU (MD-0101) is attached to the copier,
open it.
8. Open side cover.
9. Open front cover.
Fig. 12-6-2
10. Remove 3 screws and remove DEV. motor as-
sembly.
Fig. 12-6-3
White
Black
Blue or Red
12.6 Disassembly and Replacement
[A] DEV. motor assembly
1. If a STP (KK-1600) is attached to the copier,
disconnect the power cable.
2. Detach the manual pocket.
3. Detach the toner cartridge and the process unit.
4. Detach rear cover. (See Fig. 2-6-1)
5. Remove MAIN PWA.
(See Fig. 2-6-25 and 2-6-26)
6. Detach the connectors from RELAY PWA
(CN32/CN39/CN54) and release the clamp.
To Next Page
Loading...
