e-STUDIO163/203 ADJUSTMENT December 2005 © TOSHIBA TEC
3 - 48
3.9.3 Adjustment of Skew
Note: Note:
Check if the image adjustment for the equipment is performed properly before this adjustment of
the RADF. Also, the RADF position and height shall be adjusted properly.
[A] Checking
Check the image using the chart (original) with vertical and horizontal lines in the following procedure.
Fig. 3-53 Chart (Original)
(1) Place the chart provided as an original with its face up on the original tray of the ADF, select [1
Sided -> 1 Sided] and press the [START] button.
(2) Superimpose the chart on the copy and check the inclination of the copy image.
[B] Adjustment
(1) Shift the aligning plate with the scale as the guide shown in the figure below to adjust the skew.
Fig. 3-54
To Next Page
Loading...
